Do not despair if you have noticed some errors after the finished wall hang wallpaper. Consider a few reasons for poor gluing wallpaper and options for addressing those errors.Have you noticed a partially unstuck wallpaper near the cornice and ceiling. Perhaps, after the wall was painted with the glue or lime paint, or in the process of fining was used too much liquid adhesive, as well as possible in a room papered in which the wallpaper was too hot.
But do not despair, it can be eliminated if we remove the paint from the walls or carefully spread wallpaper glue and carefully smooth them to the wall.
Curves pasted wallpaper can only perekleit. And this mistake you could because of the lack of vertical partitioning.
* Desktop behind skirting around? Necessary to bend the straggler piece of wallpaper, a well-lubricated it with glue and carefully smooth it to the wall.
* Eliminate strongly thick seams can only perekleivaniem wallpaper.
* If the glue seeping through the wallpaper (maybe because of using too much hot glue), you must re-perekleit wallpaper, but you observe the temperature of the glue no longer than 30 0C.
* When you have finished pasting wallpaper on the surface of visible wrinkles or bubbles, you must re-perekleit wallpaper, and the reason for this may be using the wrong glue or wallpaper themselves badly soaked. Also, the reason for this may be bad smoothing wallpaper or wallpaper too slowly dried up.
* If you notice that the corners of the wall torn wallpaper, you must perekleit wallpaper, and at the same time ensure that they overlapped edges in width from half to three inches. And the reason that the wallpaper torn - badly smeared glue wallpaper, which widened during pasting, and then, after drying the paper on the wall pulled.
* And finally, if you choose wallpaper with a pattern, and in the process of fining you see that picture does not match (as wallpaper mistakenly cut and pasted) to perekleit wallpaper immediately as soon noticed this error.
No comments:
Post a Comment